Enigma2 receiver setup

Enigma2 is Linux inside a set-top box — it offers a lot, but it needs configuring properly. I install and set up the system so that the receiver simply works and you do not have to come back to it.

What I do

  • Image installation and updates (OpenATV, OpenPLi and others)
  • Tuner setup for your dish: LNBs, DiSEqC, motorised mounts
  • Wired and Wi-Fi networking, remote access to the receiver
  • Programme guide (EPG) and picons
  • Recording, timeshift and external drives
  • Settings backup and quick restore after a failure or a receiver swap
  • Cleaning up after failed plugins and updates

When it is worth getting in touch

  • A new receiver is still in its box because it is not clear where to start
  • After an image update the receiver hangs or restarts
  • The EPG is empty or shows the wrong times
  • The receiver cannot see the network or keeps dropping the connection
  • You want to move settings from an old receiver to a new one

How it works

Most of the work is done remotely — the receiver has to be connected to the internet, and you switch access on for the duration of the work. I start by backing up the current settings so they can be restored. At the end you get a short note on what was set up and how to make a backup yourself.

Questions

Which receivers do I work with?

Enigma2 receivers, including Vu+ and Zgemma. Tell me the model and image version and I will say straight away whether I can help.

Do I have to post the receiver?

No. The work is done remotely over the network; the receiver stays with you, connected to the dish and the television.